Overview

matrix_ctrlr_logo_nb
matrix-ctrlr-final-design-3A CUSTOM, ARDUINO-BASED MIDI CONTROLLER FOR OBERHEIM MATRIX

matrix-ctrlr-final-design-7

matrix_ctrlr_pcb_kicad2d

 

  • Hardware 19” 3U rack
  • Compatible with Matrix 6 Keyboard, Matrix 6R Rack & Matrix 1000 Rack units
  • 32 knobs covering 50 parameters (2 virtual layers)
  • All 96 of the Matrix’s voice parameters (including the modulation matrix) editable using display and buttons
  • Control up to 4 Matrix synths at the same time
  • Full SysEx and MIDI CC implementation
  • Store and manage 1000 patches
  • Includes a powerful arpeggiator
  • Computer free!
  • Available as a DIY kit (soldering required)

 

 

matrix_ctrlr_pcb_kicad3d_a

matrix_ctrlr_pcb_kicad3d_b

WELCOME BACK IN THE FUTURE !

 

matrix_ctrlr_6r-3

 

 

 

 

 

Recent Posts

arduino Mega pin tester application

A short application to test your arduino mega and detect if there are very thin short or cold solder joints between the pins/connectors. Useful if your buttons are not detected for example (we had a defective board with a short between pin 10 and 11, disabling SRIO function scanning the buttons).

Simply upload the sketch and then with a single wire you can monitor through Serial at 115200 bauds that the pin is good : pin 13 is the output pin alternating a state 1/0 while Serial indicates if the tested pin is working. All pins are tested so you can pass from one pin to another with the monitor window opened without rebooting, simply by moving the wire.

pin10 is tested on the picture below :

 

Increase the delay(5) to delay(150) to see the source output pin blinking. Sketch to download :

testeur_Mega_one_wire_v2

 

  1. Matrix Ctrlr 1.38 update 2 Replies
  2. BLACK FRIDAY 2020 Leave a reply
  3. Summer 2020 Leave a reply
  4. Confined COVID19 Leave a reply
  5. Availability / backorder 1 Reply
  6. 2019-nCov 5 Replies
  7. Flashing an EPROM Leave a reply
  8. Shipping Leave a reply
  9. New kits availability 2 Replies